100
Adapt Digit Dial to your Voice
1. In standby mode, press the left soft key ( ) Menu.
2. Press , , for Voice Setup.
3. Press , for Adapt Digits.
Your phone displays the first digit sequence and “Please
say” plays through the speaker followed by the four digits
appearing in the display.
4. Wait for the beep and repeat the digits using your normal
tone of voice.
5. After a moment, the phone plays back the recording and
prompts “Did the recording sound ok?” If the recording
was good, say “Yes.” If you need to re-record, say “No.”
•If you say “No,” the phone prompts you to pronounce
the digits again. Wait for the beep and then re-
record. Repeat this step until you’re satisfied with
the recording.
6. After confirming that the recording sounds ok, repeat the
recording process with the next set of digits. After six
sets of digits, the phone asks whether you want to do
more adaptation. Answer “Yes.”
7. Repeat steps 4-6 for another six sets of digits. After the
sixth set of digits, the phone indicates that adaptation is
complete.
RESET DIGIT DIAL ADAPTATION
You can erase an adaptation and reset Digit Dial to its original
state.
1. In standby mode, press the left soft key ( ) Menu.
MetroA610.book Page 100 Tuesday, July 6, 2004 3:12 PM