Samsung SDZ-300 instruction manual Connecting to connection, Function, Zoom, Focus, Com

Connection

Connecting to connection
External Control Connector			GND
			MD
			COM
			FOCUS
			ZOOM
Connector	Function	Signal Level	I/O
	Tele	+6V~+12V
ZOOM		COM	I
	Wide	COM
		-6V~-12V
	Far	+6V~+12V
FOCUS		COM	I
	Near	COM
		-6V~-12V
COM		COM	-
		+4.0V~+5.0V
MD		There is motion	O
	0V	5±0.5sec
	There is no motion

*MD (Motion Detection) Output Signal Level (less than 10mA)

*When using the MD function, the 'GND' should be connected to the frame ground.

Communication Control Connector

The camera can be controlled by using external controllers like a Remote controller. (RS-485 Communication)

SCC-3000	Remote Controller	6-Pin Connection
	SCC-100	Cable

* Communication Control Connector Pin Description .

Number	Name	Description	Number	Name	Description
1	GND	-	4	TRX +	RS-485 Communication
2	EXT.SYNC	External ‘SYNC’ Signal	5	TRX -	RS-485 Communication
3	GND	-	6	Output Power	Remote Controller only

* EXT. SYNC		3V or 5V
	Min: 500ns	0V
	60Hz ± 0.1Hz(NTSC), 50Hz ± 0.1Hz(PAL)

*Communication Setting can set the communication setting as shown in the table below. When you use to connect SCC-100 or SCC-3000, the default sets for SCC-3000

ITEM	SCC-100	SCC-3000
MODE	Serial	Serial
Data Bit	8 bit	8 bit
Bit/Sec	9600bps	9600bps
Parity	EVEN	NONE
CAM ID NO.	0	1~255
RETURN PACKET	ENABLE	See the SCC-3000 manual

Notes

• Contact an authorized technician for inspection.

COLOR CCD CAMERA 16 User’s Manual COLOR CCD CAMERA 17 User’s Manual