4) Installing the PIR Camera (SOC-C321P)

1.Choose an installation site that can sufficiently support 5 times the weight of the equipments to be installed.

2.Remove the screw (BH M2.6) at the bottom of the main unit by turning it counterclockwise, and then lift the assy-case front as you push it upward to detach it from the case-rear.

(Do not apply excessive force, as doing so may damage the inside assembly.)

Assy-case front

Screw (BH M2.6)

CASE-REAR

3.Place the case-rear over the installation site and mark screw holes with a pencil (indicated by the circles in the illustration). Drill a pilot hole for each pencil mark (5mm in diameter and at least 35mm in depth), and then fully insert the supplied plastic anchors (HUD 5) into them.

English-21

Page 21
Image 21
Samsung SMO-150QP/UMG, SMO-150QPV manual English-21, Installing the PIR Camera SOC-C321P