Samsung SP-L250, SP-L200, SP-L220 manual Remote Control Signal Receiver

Action 4

Action 5

Action 6

to Cooling mode, because the internal temperature of the projector has increased beyond the maintenance limit.

If the internal temperature of the projector increases higher than the limit, it is turned off automatically.

The lamp

malfunctions after power turns off

abnormally or after powering on right after turning off the projector.

*Cooling mode: The fan speed has increased and the projector lamp has been changed to ECO mode.

Check whether the ventilating hole of the projector is blocked. Check the air filter and clean if blocked.

Check whether the surrounding temperature of the projector is higher than the standard temperature range of the projector.

Cool the projector sufficiently and operate it again.

Check whether the ventilating hole of the projector is blocked. Check the air filter and clean if blocked.

Check whether the surrounding temperature of the projector is higher than the standard temperature range of the projector.

Cool the projector sufficiently and operate it again.

If the same problem occurs continually, contact your product distributor or service center.

Turn the power off, wait for a sufficient amount of cooling time and then turn the power on to operate. If the same problem occurs continually, contact your product distributor or service center.

This Projector uses a cooling fan system to keep the unit from overheating. Operation of the cooling fan may cause noise, which does not affect the product performance and is part of normal operation.

Rear Side

1. PC OUT port		6.	[AV IN] S-VIDEO Input port
2. AUDIO OUT port		7.	[PC IN1,2] PC Input port
3. RS-232C port (For service input		8.	[PC IN1,2] AUDIO Input port
	terminals)
		9.	Remote Control Signal Receiver
4.	[AV IN] R-AUDIO-L Input port
		10.POWER Input port
5.	[AV IN] VIDEO Input port