SPEED DOME CAMERA User’s Manual
57
ENGLISH
SPEED DOME CAMERA User’s Manual
56
ON/OFF : It can be set up how long the operation will be kept when the motion is
detected. (1-59 sec, 1-59 min)
Power On Reset : Camera is initialized into the original status of power input.
MD Dwell Time : When the Motion Detection function is on, the motion of
intruders can be detected. When the motion is detected, the
Alarm signal is displayed in the Alarm Output Terminal. For
detailed settings of the Motion Detection for each Preset menu,
see page 43 and 44.
Alarm Setting
Alarm Enable ON
Alarm Input
Alarm Output
MD Dwell Time OFF
Alarm Setting
Alarm Enable ON
Alarm Input
Alarm Output
MD Dwell Time ON 30 SEC
Functional Description
Factory Default Settings: Camera is initialized into the factory default settings.
Data including Preset is deleted. This function is used
for initialization all settings.
Camera Default Settings: If only the camera module is replaced due to camera
module failure, the new camera module can be set up
with the settings of the old camera module.
Auto Refresh : The electric circuit and the status of the equipment parts within
the camera are optimized regularly. (The cycle can be set up.) If
camera faces toward a certain source of light or if the settings
cannot be kept because of the long time rotation filming of a certain
area, the Auto Refresh function is used to maintain and re-set the
existing camera settings. Default setting is OFF.
OFF, 1-7 Days : This function is disabled in the OFF mode. 1-7 Days enables the
Auto Refresh operation in the interval of the selected days. Auto
Refresh takes less than 10 seconds. The message “Auto Refresh”
disappears after finishing the operation.
Main Menu
Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
Initialize
Status
Initialize
Power ON Reset
Factory Default Set
Camera Default Set
Auto Refresh OFF
6) Initialization Setting
• Initialization Menu
OUT1 OFF/OUT2 OFF : If you want to cancel the operating Alarm outputs at
once, select the corresponding menu to cancel the
operating Alarm.
Main Menu
Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
Initialize
Status
Camera Status
CAM MODEL = 30NC
CAM VERSION = 03.06
DOME VERSION = 00.18
CON PROTOCOL = SAMSUNG TW
DOME ID = 001
CONTROLLER = Duplex-9600
Cam Model = 30NC
Cam Version = 03.06
Dome Version = 00.01
Dome ID=001
Controller=Duplex-9600
Camera Model
Camera S/W Version
Control Board S/W Version
Dome Camera ID
Communication Mode Setup
7) Status
The status of dome camera setting is displayed.