16
4 Remove four large screws from the rear side of the display.
5 Insert the hexagonal bolts, dish-type washers, and insulation rubber into the
four screwholes as shown in the following figure:
ŒHexagonal bolt
´Dish-type washer
ˇInsulation rubber
6 Put the insulation rubber point protruding from the rear top of the display in
the groove on the top of the wall attachment panel. Lift up the display a little
bit so that the insulation rubber point at the bottom of the rear side of the
display is put to the groove at the bottom of the wall attachment panel.
(Do not lift the display with any pressure. The insulation rubber at the top may
be taken off. )
Œ
ˇ
´
AA68-01689A-1 4/12/05 10:46 AM Page 16