1 See the drawing of the wall attachment panel shown in page 14 to check for
the stability of the wall where the PDP is to be installed. If the wall is not
enough strong to support the PDP, strengthen the wall before installation.
2 Fix the wall attachment panel on the wall using bolts as shown in the following
figure: Fixing bolts must protrude from the wall appox. 0.6 inches.
3 Using the wall attachment panel, you may adjust the angle of the display from
0 to 20 degrees. The angle can be set in 5 stages with 5 degrees of distance
each using the angle control holes on the sides of the panel.
15
Installing the Display on the Wall Attachment Panel:
When the angle
has been set to 5
degrees.
When the angle
has been set to
15 degrees.
When the panel
hasn't been tilted.
Angle control holes
5 degrees of tilt
10 degrees of tilt
15 degrees of tilt
20 degrees of tilt
No tilt
Continued...
AA68-01689A-1 4/12/05 10:46 AM Page 15