5. Be sure to note the correct direction that the paper comes off the roll.

6. Pull out a small amount of paper, as shown. Then close the cover.

Notes : When closing the cover, press the center of printer cover firmly to prevent paper miss-loading

7. Tear off the paper as shown.

1-7. Adjustments and Settings

The SRP-350 is set up at the factory to be appropriate for almost all users. It does, however, offer some settings for users with special requirements.

It has DIP switches that allow you to change communication settings, such as handshaking and parity check, as well as print density.

The SRP-350 also has a near-end sensor for the paper. This can give you a warning when the paper is almost out. If you find that there is not enough paper remaining on the roll when the near-end sensor is triggered, you can change the near-end sensor setting. Rotate the near end sensor tab at front or rear position.(See the below figure)

10

11

Page 6
Image 6
Samsung SRP-350 specifications Adjustments and Settings