Chapter 2. Connecting the Cable
2-1. Connecting the AC adapter to your printer
When the printer is used, use te optional AC adapter,
Using an incorrect power supply may cause fire or electrical.
When connecting or disconnecting the power supply from the printer, make sure that the power supply is not plugged into an electrical outlet ; otherwise you may damage the power supply or the printer
1.Make sure that the printer's power switch is turned off, and that the power supply's power cord is unplugged from the electrical outlet.
2.Check the label on the power supply to make sure that the requird voltage matches that of your electrical outlet.
3.Plug the power supply's DC cable connector into the printer's power connector as shown below.
4. Plug the AC adapter's power cord into an electrical outlet.
NOTE
To remove the DC cable connector grasp the connector at the arrow and pull it straight out. Make sure that the main unit's power cord is unplugged before you disconnect the DC cable connector.
2-2. Connecting the printer to your Computer
STP-102S
You need an appropriate serial interface cable to connect your computer to the printer's
1.Make sure that both the printer and computer are turned off :
then plug the cable connector securely into the printer's interface connector.
2.Tighten the screws on both sides of the cable connector.
25 Pin Male Type
3. Plug the other end of the cable into the computer
78
