Samsung SW-252 warranty Technical Specifications, Problem, Meaning / Solution

Problem	Meaning / Solution
When the MPEG software	Adjust the size of the replay screen.
plays a Video CD, the
	After checking the display resolution, adjust it,
pictures are not regular and
	if necessary.
the running speed is too slow.
The Disc is not in message is	The computer may not recognize the disc if you
displayed even though a disc	start playback too quickly after inserting the disc.
has been inserted.	Open and close the disc compartment and try again.
	Clean the disc and try again.
The CD-R/RW drive is not	The interface mode of the sound card is AT-BUS.
detected after it is connected	You must therefore connect the CD-R/RW drive to
to a sound card.	the IDE port on the PC mother board, rather than
	to the sound card, or install an E-IDE compatible
	sound card.
IN CD has the Formatted	Right-click the mouse on TRAY ICON (right side of
Disc Eject function.	the menu bar at the bottom of the monitor) and then
	select "Eject" to take the CD out.
	Select the drive where the disc is inserted from
	Windows Explorer.
	Right-click the mouse and select "Eject" to take
	the CD out.
When recording NERO,	This seems to occur when you select the recording
it will be recorded not on a	function as the system selects "Image Recorder"
CD but a form of image file.	instead of SW-252.
	In this case, select a recorder from the menu items
	at the upper part of NERO and then select SW-252
	from the Recorder Selection window.
	When installing the recording software, try not to
	install the software before the ROM drive as this
	makes the Image Recorder selected.
The Recorder cannot	Use the firmware automatic upgrade function
recognize the disc.	available at the ODD service website to download
	the newest firmware and then reinstall the recording
	software which is included in the bundle.
	- www.samsung-ODD.com
	- www.samsungelectronics.com

Technical Specifications

SAMSUNG continually strives to improve its products. Both the design specifications and these user instructions are thus subject to change without notice.

	ITEM			SW-252
DISC	Disc types supported		CD-DA(Audio), CD - ROM, CD - ROM XA, CD - Plus,
	in read mode		CD-Extra, Photo - CD(Single, Multi - session), Video CD
			ready, Enhanced CD, CD-I/FMV, CD-R, CD-RW, CD-TEXT
	Disc types supported		CD-R, CD-RW
	in write mode
	Erasing disc types		CD-RW
	Disc diameter		120 mm or 80 mm
DRIVE	Data	Recording	CD-R : 7800KB/sec(52X), 7200KB/sec(48X),
PERFORMANCE	transfer rate		6000KB/sec(40X),4800KB/sec(32X),
			3600KB/sec(24X), 2400KB/sec(16X),
			1800KB/sec(12X), 1200KB/sec( 8X), 600KB/sec(4X)
			CD-RW :4800KB/sec(32X), 3600KB/sec(24X),
			1500KB/sec(10X), 600KB/sec(4X)
		Reading	CD: CAV 52 Access Time		CD-R/RW : CAV 40 Access Time
			PIO mode 4: 16.6MB/sec, Multiword DMA mode2: 16.6MB/sec,
			UDMA mode2 :33.3MB/sec
	Access time (typical)		100ms (typical)
	Data Buffer		8MB
	Laser		Semiconductor laser
	Slide mechanism		Stepping motor
	Spindle motor		Brushless motor
	Load mechanism		Tray. DC motor (Soft Eject).
ERROR RATE			Mode 1:10-12,	Mode 2:10-9
FRONT PANEL	Eject button		Auto eject or Auto inject
	Indicator		Play / Read (GREEN) Record (RED), Operation LED
	Headphone output		Stereo mini-jack (Ø 3.6 mm) 0.65±20% (vrms) 33Ω
	Volume control		(Wheel Knob)
REAR PANEL	Required power		+5 VDC: 1.5 A (Peak), +12 VDC: 1.5 A (Peak)
	Interface connector		ATAPI BUS(E-IDE)
	Audio output		Line out 0.75±20% (vrms) : 47KΩ
	Jumper block		Device configuration jumper
OPERATING	Operations		Temperature:	5~45°C	Humidity: 10~80%
ENVIRONMENT
	Storage		Temperature: -25~60°C		Humidity: 10~90%
GENERAL	Dimensions		148.2 (W) x 42 (H) x 184 (D) mm (including bezel)
	Net weight		750g
RELIABILITY	MTBF		100,000 POH(Duty 25%)

15 16