③Select the following order to change Wireless Channel.
CMD(t,p,h): 2 ↵ | Enter Current Channel |
| |
Enter new Channel |
|
|
|
Enter the proper channel number after the phrase “Enter new Channel {1- 14}:”. Then, press [ENTER : ↵ ]. Channel index should be between 1 and 14(differs from country to country).
Notice : If you are operating two or more Access Points in the adjoining cells, keep the appropriate channel distance to avoid the interference. We recommend you to keep the distance of at least 4 channels in the adjoining cells.
④Only if AP is used for DHCP Client, you set DHCP Client with “Enabled”. In this case, there is no need to set ⑤, ⑥, ⑦ below. The default setting is “Disabled”.
CMD(t,p,h): 3 ↵ | Enter DHCP | Client | |
Setting Selection | |||
| |||
Enter new DHCP Client {enable, disable}: disable ↵ |
|
| |
|
|
| |
⑤Select the following order to set IP Address.
CMD(t,p,h): 4 ↵ | Enter IP Address |
| |
Enter new IP Address : 16.3.60.208 ↵ |
|
|
|
Enter the proper IP address after “Enter new IP Address :”. Then, press
[ENTER : ↵ ]. Consult your system administrator for setting the proper value of IP Address.
65
