Securing the TV to the Wall

Caution: Pulling, pushing, or climbing on the TV may cause the TV to fall. In particular, ensure that your children do not hang on to or destabilize the TV. Doing so may cause the TV to tip over, resulting in serious injuries or death. Follow all safety precautions provided in the Safety Flyer included with your TV. For added stability and safety, you can purchase and install the anti-fall device as described below.

To Avoid the TV from Falling

1.Put the screws into the clamps and firmly fasten them into the wall. Confirm

that the screws have been firmly installed into the wall.

-- You may need additional material such as anchors depending on the type of wall.

-- Since the necessary clamps, screws, and string are not supplied, please purchase these additionally.

2.Remove the screws from the centre back of the TV, put the screws into the clamps, and then fasten the screws into the TV again.

-- Screws may not be supplied with the product. In this case, please

 

purchase screws of the following specifications.

 

-- Screw Specifications:

 

LED 5 Series: For a 32 ~ 40 inches: M6 / 46 ~ 50 inches: M8

 

LED 6 Series: For a 40 inches: M6 / 46 ~ 60 inches: M8

 

3. Connect the clamps fixed into the TV and the clamps fixed onto the wall with a

wall

strong cable and then tie the string tightly.

-- The product colour and shape may

-- Install the TV close to the wall so that it does not fall backwards.

vary depending on the model.

-- It is safe connecting the string so that the clamps fixed onto the wall are

 

equal to or lower than the clamps fixed on the TV.

 

-- Untie the string before moving the TV.

 

4.Verify that all connections are properly secured. Periodically check connections for any sign of damage. If you have any doubt about the security of your connections, contact a professional installer.

Arrange the cables using the Cable Holder

English - 6

Page 27
Image 27
Samsung UE46H6233AKXRU, UE40H6233AKXRU manual Securing the TV to the Wall, Arrange the cables using the Cable Holder