IR Blaster
To control to external devices connected to your TV, setting up the Universal Remote.
If you control Smart Touch Control to adjust to the external device, the IR Blaster will send the IR signal to an external device.
Pairing Button
OPEN
PAIRING
1
Power Switch | OFF | 1 |
| ON | 2 |
|
| |
|
| OPEN |
Installing batteries (Battery size : AA)
1
1 | OPEN |
2 | OPEN |
| |
1 | OPEN |
| |
| OPEN |
Device Indicator LED
IR Blaster shows the pairing state.
1.Hold the both sides of the battery holder and pull it out.
2.Install four batteries so that the polarity of the batteries
3.Push it back.
Initial Pairing
When you connect an IR Blaster with your TV, you can control connected external devices with your TV using the Smart Touch Control.
IR receiver |
|
|
| • | Smart Touch Control |
30cm ~ 4m |
|
|
| • | IR Blaster |
<Connecting> | <Pairing complete> | |
Smart Touch Control
After you have run the Initial Setup on your TV, you should connect your Smart Touch Control to your TV.
1.Turn the TV on by pressing the Pbutton on.
2.The connection icons appear on the bottom left of the screen, and the TV connects to your Smart Touch Control automatically.
✎If you want to perform the pairing process again, press the reset button in the centre of the back cover using a pin or the tip of an unbent paper clip. The Smart Touch Control will be initialized.
• Smart Touch Control PAIRING Reset button
IR Blaster
1.Turn on the IR Blaster. When Indicator LED blinks, you should connect IR Blaster to TV.
2.Move the IR Blaster to the direction of your TV's IR receiver, and then press the PAIRING button once
OPEN | shortly on the bottom of the IR Blaster. |
PAIRING | 3. The connection icons appear on the bottom left of the screen, and the TV connects to IR Blaster |
ON | automatically. |
OFF |
|
PENO | ✎ If the connection process failed, please turn off and on the IR Blaster, try again from step2. |
English - 7
