Maintenance
Note: For easier access, the entire Upper Tank may be removed by turning the knob on the back
of the cleaner to unlock and pulling the entire tank straight out.
The belt
The belt on your cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the bottom plate of the cleaner and should be checked from time to time to be sure it is in good condition.
Cleaning The Pre-Motor and Post-Motor Filters
Filter |
P r e - M o t o r |
Filter |
The
It is located in the slide out tray underneath the Dirt
Container. If the filter becomes dirty, pull out the tray, lift
out the filter and clean.
The
Note: A white, pleated HEPA Media Filter is offered as an optional item. This filter is not washable and must be replaced.
How to replace
Disconnect cleaner from electrical outlet.
Place handle in low position and turn cleaner over so bottom side is up. Remove the 4 screws as shown with a screw driver.
With lettering on outside of belt and positioned as shown in box on (D), slide new belt over motor pulley (B).
When to replace
Disconnect cleaner from electrical outlet.
To check belt, remove bottom plate as shown in “How to replace.” Replace belt it is stretched, cut or broken.
Remove agitator and used belt. Discard used belt.
WARNING:
Do Not operate cleaner with damp or wet filters or without all
filters in place.
Insert agitator through belt and place belt in belt guide (C) on agitator.
Should the agitator shield (D) become dislodged while replacing the belt or the agitator, reposition it as shown, noting the placement of its belt guide (D)
5
