INSTALLING THE BUTTON TYPE BATTERY

Installing the button type battery in the remote control

1.Turn the battery holder counterclockwise (as indicated with () mark) using your fingernail or a coin to open it. The battery holder opens.

2.Insert the battery into the battery holder with the positive (+) terminal facing down and press it firmly until you hear a locking sound.

3.Place the battery holder back in the remote control, match its () mark with the () mark on the remote control, and turn the battery holder clockwise to lock it.

Precautions regarding the button type battery

•There is a danger of explosion if button type battery is incorrectly replaced. Replace only with the same or equivalent type.

•Do not pick up the battery using tweezers or other metal tools. This will cause a short circuit.

•Do not recharge, disassemble, heat or immerse the battery in water, to avoid the risk of explosion.

Keep the button type battery out of the reach of the children. WARNING Should any battery be swallowed, consult a doctor immediately.

USING THE CRADLE

1

2

Battery

holder 3

• The cradle is a connection plate which can be used to make the camcorder more stable when charging the

battery, or connecting to an external device (TV, PC, etc.).

•You have to connect the AC power adaptor to the cradle when connecting external devices using the cradle.

•If you connect your HD camcorder to the provided cradle using more than one type of cable to output image, the order of priority of the output signal is as follows:

USB cable HDMI cable Component/Multi-AV cable.

•If you connect the camcorder to the cradle, USB and Component/Multi-AV jack of the camcorder are not operated.

•Do not connect the connection cables to HD camcorder and cradle at the same time, it may cause conflict and may not work properly. If this occurs, remove all the connected cables and try the connection again.

Cradle receptacle

DC IN jack

 

USB jack

HDMI jack

Component/Multi-AV jack

English _11