Information codes
<SR10M701*** series> |
|
1 The three | 2 Turn off the |
indicators below | emergency switch |
blink and an | and check the |
information | below instructions |
codes alarm | and take |
sounds. | appropriate action |
3 Information code will disappear when you turn on the emergency switch
Information codes animation |
|
| Information codes |
Information codes | Checklist |
The POWERbot is caught, stuck or trapped while moving around.
ffTurn off the emergency switch and move the POWERbot to another area.
Foreign matter caught in the brush.
ffTurn off the emergency switch and remove the foreign matter from the brush.
Foreign matter caught in the left Driving wheel.
ffTurn off the emergency switch and remove the foreign matter from the Driving wheel.
Foreign matter caught in the right Driving wheel.
ffTurn off the emergency switch and remove the foreign matter from the Driving wheel.
Bumper sensor needs to be checked.
ffTurn off the emergency switch and turn it back on.
ffWhen information code does not disappear, check if there's any small foreign matter between the bumper and the main body. If there is, pull the bumper slightly and remove the foreign matter.
Foreign matter accumulated on the obstacle sensor.
ffTurn off the emergency switch and clean the front and rear sensor with a soft cloth.
Foreign matter accumulated on the cliff sensor.
ffTurn off the emergency switch and clean the cliff sensor with a soft cloth.
Main PCB needs to be checked.
ffTurn off and restart the product. If the same problem occurs repeatedly, a service check is required.
