Assembling the RAT Protection Panel

1.Insert the rat protection panel to the assembling hole on front side to the end.

2 .If you have difficulty

inserting the panel lift up the washer a little and insert it

IN CASE OF PUMP-DRAINED WASHER

Take out the cap-hose and connect the outlet-hose.

Be sure to join tightly the drain hose into the drain-outlet on the back of the machine.

Be sure to join tightly the drain hose into the drain-outlet

on the side of the machine.

Install the drain hose in the position of about 90~100cm above the ground.

cap-hose

90~100cm70~80cm

outlet-hose

CONNECTING THE DRAIN HOSE	(a)
After pressing the joint ring(a), insert the drain hose(b)
to drain direction.

(b)

1 .Open the detergent box by pulling in the direction of the arrow as shown in the figure and then put the powder detergent in the detergent box.

2 . Put in one-time amount of detergent evenly so the detergent may not brim over the box.

Detergent Device

Put the detergent in proportion to water level

Softener Device

Softener

baseline

CAUTION : If softener is stored over the above base line, it may flow down at any time.