How to Install Network Termination | Trane BACnet Option Module

How to Install

Network Termination

Connecting the Bus Line

Connect the BACnet Option Card to the bus line via terminals 62, 63 and 66. Terminal 62 is marked red and Terminal 63 is marked green. These two are the RS485 lines. Terminal 66 the signal ground for the RS485 transmitter.

Maximum Cable Lengths

Maximum total bus cable length: 4000 ft [1200 m]

3-4	TR200 BACnet

Image 19

Trane BACnet Option Module, TR200 How to Install Network Termination, Connecting the Bus Line, Maximum Cable Lengths

Contents

TR200 Introduction LED Status Copyright, limitation of liability and revision rights Safety Safety Safety Note Safety High Voltage WarningSafety Regulations Installation at high altitudes Min. Waiting Time Minutes Voltage Safety Safety Precautions Protection Mode Installation requirements Safety Before Commencing Repair WorkElectrical ratings About this Manual IntroductionTechnical Overview Transport mechanism Physical characteristicsIntroduction Background information Background Knowledge Introduction AssumptionsAvailable Literature for TR200 LED MAV MOC MRV Introduction Abbreviations Installation of the Option How to Install Cable lengths and number of nodes How to InstallCabling Instructions How to Install Connecting the Bus Line How to Install Network TerminationMaximum Cable Lengths EMC Precautions How to Install Cable RoutingConnection of the Cable Shield How to Install Ground Connection Initialization Procedure How to Configure the SystemInitialization Parameter Control Word Timeout Function How to Configure the SystemBibbs Name Par. number Value How to Configure the System Closed-loop How to Control the Adjustable Frequency DriveReference Handling Open-loop Analog Input and Output Objects How to Control the Adjustable Frequency Drive Rameter Notifi Timeout Scription Rameter Bus Change- Non-vola Alarm Triggers Object Name Able DeCation Timeout Object Non-vola Alarm Triggers Bus Able De BO30 Reserved Output Write Timeout Scription Change Non-vola AlarmObject Name Able De Change Non-vola Alarm Object Name Able De How to Control the Adjustable Frequency DriveTriggers Bus Timeout BV80 Broken Belt BV121 10V low BV156 Reserved, P Multi-state Input and Output Objects Change- Non-vola Alarm Object Name Able DeDrive Par Write Object Read Change- Non-vola Real Time Clock VariableWrite Scription Adjustable Frequency Drive Feedback to Network Output Value Stage Output ValueValue Class Multi Stage File value Event notifi- cation class Object / Property Support Matrix Device Binary How to Control the Adjustable Frequency Drive Parameters Title Default value Range Conver Data Sion index TypeParameter List Control Site Control Timeout TimeParameters Comm. and Options End-of-Timeout Function Control Timeout Function Protocol Reset Control TimeoutDiagnosis Trigger Control Profile Parity / Stop Bits ParametersAddress Baud Rate Coasting Select Minimum Response DelayMax Response Delay Max Inter-Char Delay Reverse Select Start SelectSet-up Select 72 MS/TP Max Masters Preset Reference SelectInitialization Password BACnet Device Instance General TroubleshootingAlarm and Warning Messages Alarms Bit Alarm Word Hex Par.16-90 Alarm Word Troubleshooting Alarm WordsAlarm word, par.16-90 Alarm Word Alarm word 2, par.16-91 Alarm word Bit Hex Par.16-92 Warning Word TroubleshootingBit LED 1 Net Status Phases Status Bi-color LEDLED 2 Module Status MG12L122 *MG12L122