Washing for the first time
Before starting to wash, check the following:
1.Connect the water supply hose to the water tap. Open the tap. Connect the power to the washer. Ensure that the drain hose is placed properly.
2.Make the drain hose in installed properly.
Before performing a wash for the first time, you must run a complete cycle without adding any laundry.
1.Press the Power button.
2.Open the detergent drawer and insert a little detergent.
3.Turn on the water supply to the washer.
4.Press the Start/Pause button.
This will remove any water remaining from the manufacturer’s test run.
Automatic sensing function
Your washer is equipped with an automatic sensing function which automatically senses the amount of laundry and the appropriate water level, wash time, rinse cycle, and spin time.
This does not apply for the Delicate, Clean tub and Super clean courses.
After the power is on, a course is selected and the Start/Pause button is pressed, the washing board starts spinning without water. This action senses how much laundry is in the washing basket, and this is not a machine problem. After the sensing process has completed, water is supplied automatically.
Place the laundry into the washer and add detergent.
•Be careful not to overload the washer. Use the appropriate detergent for the type of fabrics you are washing.
•If the lid is opened while the washer is running, the washer stops automatically for safety reasons. (However, the water supply continues while the lid is open.)
•When hot or warm water is selected, cold water is supplied for the first few seconds in order to protect the clothes.
•It is possible to control the wash time, rinse cycle, and spin time for every cycle during the wash course.
washing a load of laundry _21
02was hngi a load o flaundr
y
|
| ||
|
| ||
|
|
|
|