HOW TO WASH AUTOMATICALLY DEPENDS ON THE LAUNDRY
Before starting washing, check the following;
•Connect the water supply hose to the water tap. Leave a tap open. Plug the power cord in. Make sure to lay down the drain hose.
Washing for the first time
Before washing clothes for the fi rst time, you must run a complete cycle without clothes. To do this:
1.Press the Power button.
2.Open the detergent drawer and insert a little detergent.
3.Turn on the water supply to the washing machine.
4.Press the Start/Pause button.
This will remove any water from the manufacturer’s test run remaining in the machine.
Special notes!
Automatic Sensing Function
•According to the selected program, the amount of laundry is automatically sensed and then the appropriate water level, wash time, rinse cycle, and spinning time are automatically selected for the automatic wash.
•After the power is on, a program is selected and Start/Pause button is pressed. Then, the washing board starts spinning without water. This action senses how much laundry is in the washing basket, not a machine problem. After this sensing process, water supplies automatically.
Adding Detergent and Softener
•It senses the amount of laundry and indicates the water level and amount of detergent. Then, it starts water supply right away.
•During the water supply, it is possible to open the detergent box and add detergent. However, it is better to press Start/Pause button to stop water supply and add detergent. Close the lid and press Start/Pause button again. This way is much more convenient.
•If the softener is applied to the softener dispenser, it is automatically dispensed in the rinse cycle. To dispense the fabric softener automatically, make sure you have selected all the necessary cycles of washing, rinse, and spin.
Put the laundry into the washer and add detergent, too.
•Be careful not to overload. Use right detergent for the fabrics you are washing.
• For safety, the washing machine stops operation if the lid is open unless in water supply mode.
(Some models display an error message if the lid is open while water is being supplied.)
•When hot water is selected, both cold and hot water are supplied for the first 20 seconds in order to protect the clothes.
•Possible to control the washing time, rinsing cycle, and spinning time at every program during the washing.
SETTING UP YOUR WASHER
English - 9
WA70H4200S_03414E_EN.indd Sec3:9 |
