ENGLISH

Step 6: Add Safety Bolts (Tilting Monitor Brackets only)

Thread a Safety Bolt (I) into the bottom portion of each Tilting Monitor Bracket (D & E) approximately 1/4″ as shown in Diagram 6.

NOTE: Do not tighten the Safety bolt (I). The Safety Bolt is tightened after the television and Tilting Monitor Brackets (D & E) are attached to the Wall Plate Assembly (A).

Diagram 6

D & E

I

Step 7: Configure Wall Plate Assembly

The Wall Plate Assembly (A) can be adjusted in width from 27″ to 42″ [686 mm to 1067 mm]. Determine how wide you want the Wall Plate Assembly based on the following criteria:

Width of television (Wall Plate Assembly should be configured so the total width is less than the overall width of your television)

Width of Hole Pattern on television (Wall Plate Assembly should be wider than the horizontal distance between threaded inserts on the back of your TV by at least 2″ [50.8 mm])

Stud Spacing (Sanus recommends attaching Wall Plate Assembly to three studs for televisions over 125 lbs. [56.7 Kg])

To adjust the width of the Wall Plate Assembly (A):

Remove each Flange Nut and Nylon Washer as shown in Diagram 7A

Remove the Center Plate of the Wall Plate Assembly (A) as shown in Diagram 7B.

Seperate the Left and Right Extension of the Wall Plate Assembly (A) and set them to so that their outer edges are equal to the desired width; then, insert the Center Plate so the teeth on its bottom fit into the slots in the Left and Right Extension, making sure that the Threaded Studs fit through the center row on holes in the Center Plate as shown in Diagram 7C.

Nylon

Diagram 7A

 

Washer

 

Flange

 

Nut

 

 

Diagram 7B

Diagram 7C

Left Center

ExtensionPlate

Wall Plate

Assembly (A)

Center

Plate

Right

Extension

Threaded

Studs

VMPL3_051106_ML.indd 10

7/17/06 11:37:14 AM

Page 10
Image 10
Sanus Systems VMPL3 manual Add Safety Bolts Tilting Monitor Brackets only, Diagram Configure Wall Plate Assembly