3-4. Remove the Grille to Install the Indoor Unit
Basically, these models can be installed and wired with- out removing the grille. If access to any internal part is needed, follow the steps as given below:
How to remove the grille
(1)Set the flap in the horizontal position.
(2)Unscrew the screws. (Fig. 16a or 16b)
(3)Remove the grille. (Fig. 17)
(a)Hold both corners of the air intake grille, then pull out and up to open.
(b)Pull the lower part of the grille toward you to remove.
(c)Use a standard screwdriver to push up the 3 tabs to remove the grille.
How to replace the grille
(1)Close the flaps.
(2)Reinstall the grille into the lower part while aligning its tabs on the upper part. (Fig. 18) Insert the tabs in the slots and push the lower part of the grille back into position.
(3)Press at each of the 4 tabs to completely close the grille. Make sure that the grille and frame are firmly fitted together. (Fig. 19)
KS0951, KS1251
Screw cover
Flap
(Up and down air direction louvre)
Fig. 16a
KS1852
Fig. 16b
Air intake grille
Fig. 17
Fig. 18
Fig. 19
8
