Sanyo CDP-M303 Power Supply Handling Compact Discs, Alkaline Battery Installation not Supplied

COMPACT

DIGITAL AUDIO

05

POWER SUPPLY

06

HANDLING COMPACT DISCS

Plug one end of the AC adaptor into the DC IN jack, then plug the other end into AC wall outlet.

Precautions on using the AC Adaptor

￿Do not touch the AC adaptor with wet hands. Doing so is dangerous, as this could result in an electrical shock.

￿If the AC adaptor is connected when the batteries are installed, the power supply automatically switches to the AC power s o u r c e a n d t h e b a t t e r i e s a r e disconnected.

NOTE: The plug style of the product may be different from the drawing in the instruction manual, please solve the problem by using your own switching plug.

ALKALINE BATTERY INSTALLATION (NOT SUPPLIED)

Insert two AA batteries (not supplied) into the battery compartment on the bottom of the unit. Be sure to observe the proper polarity (the "+" and "-" signs) as indicated inside the battery compartment.

NOTE ON ALKALINE BATTERIES

￿When replacing the alkaline batteries, use two new batteries of the same type. Do not mix a used battery with a new one or mix different types of batteries.

￿When inserting the batteries, mistakenly inserting even one with improper polarity will cause leakage.

￿Never charge, heat, disassemble, or throw batteries into a fire.

REMEMBER

￿If the symbol " " flashes in the display, your batteries are weak. Replace them or use the AC Adapter.

￿ If the display is blank (no numbers show when PLAY/PAUSE button is pushed) the batteries are dead. Replace them or use AC Adapter, or Cigarette Lighter Adapter (Also check if you inserted the batteries according to the "+" and "-" as shown on set).

IMPORTANT NOTE

Spent or discharged batteries must be recycled or disposed of properly in compliance with all applicable laws. For detailed information, contact your local county solid waste authority.

This unit is designed to play compact discs bearing the identification logo (right).

Discs that do not carry this logo may not conform to the CD standard and may not play properly.

Dirty, scratched, or warped discs may cause skipping or noise. Pay attention to the following: Handle the disc only by the edges. To keep the disc clean, do not touch the surface of the disc.

￿Discs should be returned to their cases after use to avoid serious scratches that could cause the laser pickup to skip.

￿Do not expose discs to direct sunlight, high humidity, or high temperatures for extended periods. Prolonged exposure to high temperatures can warp the disc.

￿Do not apply paper or write anything on either side of the compact disc. Sharp writing instruments, or the inks used in

CLEANING DISCS

￿Fingerprints should be wiped from the surface of the disc with a soft cloth. Unlike conventional records, compact discs have no grooves to collect dust and microscopic debris, so gently wiping them with cloth should remove most of the particles. Wipe in a straight motion from the inside to the outside of the disc.

￿Never use such chemicals as record cleaning sprays, anti-static sprays, benzene or thinner to clean compact discs. Such chemicals can damage the plastic of the disc.

￿The unit will not play a disc that has been inserted upside down, or discs that do not conform to the Compact Disc standard. Also, the unit might not play discs that are scratched, soiled or carry fingerprints.

￿3" (8cm) CDs can be played without an adaptor.

￿MP3 discs are handled in the same manner.