Sanyo DP36671, DP32671, DP26671 manual Quick guide for menu operation, Channel number Station name

DISPLAY

Press DISPLAY to display the current information on the screen.

When the TV receives a digital signal, the digital information will appear.

	62-1	HDTV Moving Picture1	Sleep Timer
	CH-1	TV-MA	Off
	Digital Air		English
	No Program Information is available
	Full
	1080i
• Channel number				•	Station name
•	Channel label (if preset) •				Broadcast program name
•	V-Chip rating			•	Signal type
•	Sleep timer			•	Audio language
•	Program guide			•	Picture size
•	Resolution

When the TV receives an analog signal, the analog information will appear.

14Sleep Timer

OffG

Analog Cable

Mono

Full

480i

•	Channel number	• Channel label (if preset)
•	V-Chip rating	•	Signal type
•	Sleep timer	•	Picture size
•	Audio information	•	Resolution
	(Stereo, SAP or Mono)

Press DISPLAY again to clear the call display.

NOTE:

• After a few seconds, DISPLAY screen will return to normal TV-operation automatically.

RECALL

This button allows you to go back to the last channel selected by pressing RECALL. Press RECALL again to return to the last channel you were watching.

MUTE

Press MUTE to switch off the sound. The TV’s sound will be silenced and “Mute” will appear on the screen. The sound can be switched back on by pressing this button again or the VOL + or –.

SLEEP

To set the TV to turn off after a preset amount of time, press SLEEP on the remote control. The clock will count up 10 minutes for each press of the SLEEP but- ton (Off, 0h 10m, 0h 20m, ..., 2h 0m). After the sleep time is programmed, the display will appear briefly every ten minutes to remind you that the sleep timer is operating. To confirm the sleep timer setting, press SLEEP and the remaining time will be displayed for a few seconds. To cancel the sleep timer, press SLEEP repeatedly until the display turns to Off.

Quick guide for menu operation

Call menu and for example: Select Language. 1 Press INPUT SELECT to select TV mode.

2 Press TV MENU. The TV menu screen will appear.

Main Menu

			Picture	>>
			Audio
		CH	Channel
			Lock
			Setup
3			:Select	ENTER :Set
	Press ▲ or ▼ to select “Setup”, then press ▶ or
	ENTER.

4 Press ▲ or ▼ to select “Language”, then press ◀ or ▶ to select the desired language.

…on the following pages the menu can be called in the same way as here.

5 Press EXIT to return to the normal screen.

NOTE:

• If no buttons are pressed for more than about 60 seconds, the menu screen will return to normal operation automatically.

18

56Q0221A_eng.indd 18

1/8/11 5:31:56 PM