Sanyo DP47460 Positioning the Hdtv, Getting Started, Stand Removal, Stand Assembly, Wall Mounting

Models: DP47460

1 48
Download 48 pages 9.52 Kb
Page 5
Image 5

POSITIONING THE HDTV

Always use a firm and flat surface when positioning your HDTV.

Do not position the unit in a confined area.

Allow adequate space for proper ventilation.

Do not position the HDTV where it is easily reachable by small children and may present risk of injury.

STAND REMOVAL ____________

1 Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish

2Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw.

GETTING STARTED

BATTERY INSTALLATION

Install two (2) “AAA” batteries in the remote control. (Not included)

To ensure safe operation, please observe the following precautions:

Replace both batteries at the same time. Do not use a new battery with a used battery.

There’s a risk of explosion if a battery is replaced by an incorrect type.

Do not expose the Remote Control unit to moisture or heat.

Be sure to match the “+” and signs on the batteries with marks inside the remote control.

STAND ASSEMBLY ___________

1 Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish

2Carefully insert the stand base to the bottom of the HDTV and secure the base by inserting 4 screws as indicated in the above diagram.

NOTE: If your HDTV came packed with the Stand Base unassembled, these screws will be found in the literature package.

WALL MOUNTING ____________

Wall mounting of the HDTV must be performed by a skilled person.

Use the screws you would use to attach the stand base to secure the HDTV to a wall mounting kit (not included.)

VESA standard interface: 400 x 400

Mounting screws measurements:

M6 (6mm) Diameter, Length—12mm (maximum)

ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE

Hook up your antenna or your cable service to the HDTV’s ANT terminal with the use of a 75 OHM coaxial cable.

NOTE: Keep your indoor antenna at least 3 ft. away from the television set and any other electronic equipment.

ANTENNA

ANALOG / DIGITAL

ANTENNA IN

CABLE

The tuner in this HDTV can receive:

Digital and Analog off air signals from an antenna

Analog or ClearQAM cable channels from a direct Cable TV connection.

Need help? www.sanyoctv.com 1-877-864-96045

Page 5
Image 5
Sanyo DP47460 manual Positioning the Hdtv, Getting Started, Stand Removal, Stand Assembly, Wall Mounting