Sanyo DP50747 To 120 V AC outlet, GETTING STARTED, here, POWER, terminal, CABLE OR, RF ANTENNA, PRECAUTIONS, To POWER CORD, ANALOG CHANNELS, CABLE BOX OR SATELLITE BOX

INITIAL ON-SCREEN

ALL CHANNEL SEARCH

GETTING STARTED (REQUIRED INITIAL SETUP)

1Install batteries in remote control (2AAA, not included).

PRECAUTIONS

To ensure safe operation, please observe the following precautions:

Replace both batteries at the same time. Do not use a new battery with a used battery.

Risk of explosion, if battery is replaced by an incorrect type.

Do not expose the Remote Control Unit to moisture or heat.

Match the “+” and “–” signs on the batteries with marks inside the remote control.

2Connect Signal to the DTV’s Integrated Analog / Digital 75 ohm Antenna Input

terminal.

RF ANTENNA

CABLE OR

OR

	ANALOG/
CABLE BOX OR SATELLITE BOX	DIGITAL
	ANTENNA IN

THE TUNER IN THIS PLASMA DTV CAN RECEIVE:

1.Digital and / or Analog Off-Air Signals from an RF antenna.

OR

2. Analog or ClearQAM cable channels.

Note: You must search for ClearQAM channels using

the “Digital Cable Search” menu option.

OR

3. The output from a VCR or cable box.

Digital signals can also be received through the HDMI jacks.

Signals from a Set-top (STB) Box should be received through the Video 1, 2, or 3, or HDMI Input 1, 2, or 3 jacks.

This DTV can receive ANY unscrambled RF signal being broadcast.

3Connect AC Power Cord (supplied) to the Plasma DTV and electrical outlet as shown

here.

The AC outlet must be near this equipment and must be easily accessible.

To POWER CORD

CONNECTOR on back of Plasma DTV.

To 120 V AC outlet.

4Press the POWER key. (Follow on-screen instructions).

5Perform “All Channel Search.” The All Channel Search will search for off-air digital and analog channels, and analog cable channels. The DTV can receive cable or off-air channels, but not at the same time. If after two searches the DTV

still fails to detect any channels, the DTV will tune to Video1.

ANALOG CHANNELS DIGITAL CHANNELS

➠

Note: If EXIT is pressed, the DTV will skip Channel Search and tune to Video1 without storing any channels in the Channel Map database.

Need help? Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032 5