Sanyo DS24424 Basic Set-upand Connections, jack, VCR Back, Need help, Cable Service, Initial Set-up, Satellite Receiver, VCR connect signal, directly to TV 75 ohm

Basic Set-up and Connections

QuickTips

■The TV will auto- matically select the correct Antenna mode for the type of RF signal you connect.

■TV will switch off automatically after

15 minutes if there is no signal reception (cable out or station not broadcasting).

Exception—When the Video mode is selected, the TV will not automatically switch off when signal reception has stopped for 15 minutes.

■If you move the TV to a new location, press the RESET key twice after connect- ing the signal and turning on the TV.

Need help?

Visit our Web site at

www.sanyoctv.com

or Call 1-800-877-5032

CATV FRANCHISE NOTE: Cable companies, like public utilities, are franchised by local government authorities. To receive cable programs, even with equipment which is capable of receiving cable channels, the consumer must subscribe to the cable company’s service.

Initial Set-up

1.Install batteries in remote control, see page 8.

2.Connect signal, see below.

3.Plug in AC power cord.

4.Press POWER key to turn on TV.

5.Follow on-screen instructions.

Connecting Cable Service, RF Antenna, or Satellite dish receiver to TV

Cable Service		Satellite Receiver		RF Antenna
	CH3	CATV IN
	CH3
	CH4	VIDEO	L-AUDIO-R IN FROM
		VIDEO	L-AUDIO-R IN FROM
IN OUT		OUT TO TV S-VIDEO	SAT.
IN OUT		VIDEO	L-AUDIO-R
		VIDEO	L-AUDIO-R

Note: If you do not have a	IN	VCR Back
VCR connect signal	IN
VCR connect signal	FROM ANT.
directly to TV 75 ohm	OUT
directly to TV 75 ohm	OUT TO TV		TV Back
jack.			TV Back
	COMPONENT AUDIO VIDEO		UHF/VHF/CATV
	2	INPUT 2	75Ω

Y VIDEO

PB L (MONO)

PR R

S-VIDEO

Operational Tip for No Signal Connection:

If the TV is used as a monitor only, with a DVD player or some other type of external equip- ment, and no cable or antenna signal is available, the following setup is necessary:

Your TV is designed to automatically search for available channels. Therefore, the initial start up requires that you press the MENU key, enabling the TV to automatically go through the channel search process before you can operate the TV. After the initial channel search is completed, you must press the MENU key again to complete the channel search process (may take several minutes).

After the channel search process is complete (2 searches), you can press the INPUT key on the remote control to use the TV as a monitor.

4 Basic Set-up and Connections