Sanyo DSR-M804P manual Names and Functions of Parts, Rear panel

2NAMES AND FUNCTIONS OF PARTS

Rear panel

		1		2	3	4										5	INTRODUCTION
			AUDIO			LAN				1					2 VIDEO 3		4
		3		IN	1
																	IN
		4			2
										1					2	3	4
			ALL
			RESET
					MONITOR OUT
		RS-485
		TV SYSTEM TERMINATE
		NTSC	ON
		PAL	OFF			1	2	3	4	5	6	7	8	9	10 11 12 13 14 15 16 17 18 19
		AC IN
6	7	8	9	10		11										12	13

1.FAN

2.AUDIO IN terminals (4 channels)

3.AUDIO OUT terminal

4.LAN terminal (JP. 45)

5.VIDEO IN terminals (4 channels)

6.Power cord holder

Secure the power cord to the holder using the cord tie (accessory) as shown in the illustration.

Cord tie

7.AC INLET

AC power input terminal (3-core)

8.TV SYSTEM selector switch

Used to select between NTSC and PAL systems for the camera input and monitor output connected to the digital video recorder.

zTurn the power OFF then ON again after selecting NTSC or PAL.

9.RS-485 TERMINATE switch

Turns RS-485 termination ON/OFF.

10.ALL RESET switch

Resets the clock and backup mode setting. (Menu settings are maintained)

11.VIDEO MONITOR OUT terminal

Output terminal that displays quad screen on single monitor.

12.Control and alarm terminals

Terminal	Pin	Signal
No.
1	RS485A	To RS-485 terminal signal A *1
2	RS485B	To RS-485 terminal signal B *1
3	C	Common
4	REMOTE	Remote Control terminal
5	C	Common
6	CLOCK ADJ IN	Input for clock setting
7	CLOCK ADJ OUT	Output for clock setting
8	C	Common
9	SERIES REC IN	Input terminal used when
		recording with multiple digital
		video recorders connected.
	NON REC OUT/	Output terminal used when
10		recording with multiple digital
	SERIES REC OUT	video recorders
		connected.*2
11	ALARM IN 1	Alarm input for channel 1
12	ALARM IN 2	Alarm input for channel 2
13	ALARM IN 3	Alarm input for channel 3
14	ALARM IN 4	Alarm input for channel 4
15	ALARM RESET	Alarm reset input
16	ALARM OUT	Alarm output
17	C	Common
18	WARNING OUT	Warning output *3
19	DISK FULL OUT	Recording area full warning

*1 Used for twisted-pair cable connection.

*2 SERIES REC outputs NON REC OUT when SERIES REC is “OFF”.

*3 The following warnings are output:

zHard disk drive error z Fan error z Recording error

zNo input signal when VIDEO LOSS is ON.

13.VIDEO OUTPUT terminals (4 channels)

Terminals for output of individual video channels directly to the monitor.

8 English