TROUBLESHOOTING
Sometimes a simple operational error or a mistake in the wiring can appear to be a problem with the unit Before having the unit serviced, refer to the troubleshooting chart below
Symptom | Cause | Solution |
The compact disc does not | The volume control is | Turn up the volume control |
play when inserted into the | turned down |
|
unit | The power connections are | Check the +I 2V and ground |
| not wired correctly | connections |
No power | The vehicle ignition is | Switch the ignition to the “ON” or |
| switched off | “ACC” position |
| The fuse is blown | Replace the fuse with another |
|
| 15A fuse |
The unit does not work | The microcomputer has | Eject the disc, then insert it again |
properly (Eject, Load, | been affected by electrical |
|
Play) | noise |
|
The sound from the CD | The road surface is rough | Wait for the road surface to |
player skips |
| improve before playing a disc |
| The unit is not mounted | Install the unit securely |
| securely |
|
| The disc is defective | Try another disc |
|
| If it plays properly, the first disc |
|
| may be defective |
| The disc is dirty | Clean the disc as explained on |
|
| pages |
No radio reception | The antenna cable is not | Insert the antenna cable firmly |
| connected | into the antenna jack on the unit |
The radio does not stop on | The signals are weak | Select a station using manual |
any stations when |
| tuning |
automatic tuning is used |
|
|