ELECTRONIC CONTROL RESET
Press the SEL button 0 for about 3 seconds until the unit beeps, the audio controls, except for vol- ume, will be reset
BASSXPANDER (BASX) - l/2 . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
BASSXPANDER is a
BASSXPANDERofferstwopresetmodes: | highfrequencieswhile | ||
low frequencies and reduces the high frequencies |
|
|
RADIO SELECTION BUTTON (BND) . . . . . . . . . . , . . . . . . . . . . . 5
Press the BND button 0 to switch from tape, CD player or CD changer* mode to radio
* If a CD changer is connected
Each time the button is pressed, the function changes as shown below
FM1 - FM11 - AM
TAPE SELECTION BUlTON | “.....“.“...“ | 6 |
Press the TAPE button @with a tape inserted in the tape slot to switch from radio, CD player or CD changer* mode to tape mode
* If a CD changer is connected
CD PLAYER | OR CD CHANGER* SELECTION BUTTON | 7 |
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...*.... |
Press the
or CD changer mode
* If a CD changer is connected
Pressing the button will change the mode as follows:
q When a CD is loaded in the CD player and a CD changer is not connected;
Radionape | - | CD player - | CD player pause 1 |
q When a CD is not loaded in the CD player and a CD changer is connected,
Radionape - CD changer - CD changer pause
q When a CD is loaded in the CD player and a CD changer is connected,
Radio/Tape | - | CD player - | CD changer 1 |
CLOCK BUlTON (DISP) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Press the DISP button @ to switch between the clock and audio display When an audio function is performed while the time display is selected, the audio display will appear for 5 seconds, then the display will return to the time mode
TO CANCEL THE BEEP TONES | 6 |
0 To cancel all beep tones, press TAPE button @for more than 3 seconds with no tape in the slot, and then | |
bEE ~/zFFisdisplayed | 9. |
q To turn on the beep tones again, perform the same procedure The beep tones are set and
disolaved