SPECIFICATIONSMechanical Loading
The modules should be mounted at
the 4 or more points as shown in Fig1-1 ,
Fig1-2 , Fig2-1 , Fig2-2 . Then, a maximum
loading of 2400N/m
2
(50PSF, in
static state) on the module surface
is possible.
CERTIFICATIONThe HIP-xxxNHE5, xxxNHE5-BO2,
HIP-xxxBE11, -xxxBE11-BO2
Modules comply with the
requirements of IEC61215, Electrical
protection Class II and the CE mark.
Electrical Specifications(HIP-215NHE5, -215NHE5-BO2, -210NHE5, -210NHE5-BO2, -205NHE5, -205NHE5-BO2, -200NHE5,
-200NHE5-BO2, -195NHE5, -195NHE5-BO2)
*HIT= Hetero junction with Intrinsic Thin-layer
Note: The values in the above table are nominal.
WIRINGGeneral
All wiring should be done in accordance with applicable electrical codes.
All wiring should be done by the qualified licensed professional.
Wiring should be protected to help ensure personal safety and to prevent its damage.
All modules connected in series should be of the same model number/type.
Do not connect modules in parallel without using a connection box.
3Printed in Europe 20.10.2006
Metal fitting
Spring washer
Flat washer
Module
Mounting Structure Rail
M6 Bolt/setscrew
M6 Nut
Metal fitting
(4 places)
Mounting
StructureRail
Between Modules
Mounting Structure Rail
Solar Module
Metal fitting
End of Module
φ
Installation (reference) –HIP-xxxBE11, -xxxBE11-BO2
Figure1-2 : Installation
Notes on specification
(1) Powered specifications are
measured at Standard Test Condition
Irradiance of : 1000W/m
2
, 25
o
C cell
temperature and solar spectral irradiance
per IEC 60904-3.
(2) The current output for these modules
as shown in the Specifications is
measured at Standard test conditions.
These conditions may not be frequently
observed in actual practice.
For questions regarding mounting profiles for modules, please contact your local dealer.