GETTING STARTED (REQUIRED INITIAL SETUP)

1 Install batteries in remote control (2AA, not included).

PRECAUTIONSTo ensure safe operation, please observe the following precautions:

Replace both batteries at the same time. Do not use a new battery with a used battery.

Risk of explosion, if battery is replaced by an incorrect type.

Do not expose the Remote Control Unit to moisture or heat.

Remove the batteries if the Remote Control will not be used for a month or more. Discharged batteries may leak and damage the unit.

Match the “+” and “–” signs on the batteries with marks inside the remote control.

2 Connect Signal to the DTV’s Digital 75 ohm Antenna Input terminal.

Digital (DTV) RF Antenna Connection

Connect an RF an-tenna to the Digital Antenna

In terminal.

DTV BACKRF ANTENNA

THE TUNER IN THIS DTV CAN RECEIVE:

1.Digital and / or Analog Off-Air Signals from an RF antenna.

OR

2. Analog or ClearQAM cable channels.

Note:You must search for ClearQAM channels using the “Digital Cable Search” menu option.

OR

3. The output from a VCR or cable box.

Digital signals from a Set-top (STB) Box should be received through the Component jacks.

This DTV can receive ANY unscrambled RF signal being broadcast.

(CONTINUED ON NEXT PAGE.)

13