STAND REMOVAL AND WALL MOUNTING (OPTIONAL)
Tools Needed: Phillips screwdriver
IMPORTANT NOTE: Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish.
Wall mounting of the HDTV must be performed by a skilled person.
1 Remove the two (2) screws holding the stand base cover and carefully dislodge.
2 Remove the four (4) screws securing the stand base to the HDTV. CAUTION: Hold the stand firmly as you remove the last screw.
3 Use the screws that are threaded into the four
(4)inserts on the back of your HDTV to secure it to an appropriate wall mounting kit.
VESA standard interface: 400 x 400
Mounting screws measurements:
M6 (6mm) Diameter,
NOTE: Wall mounting kit is not included.
Need help?
GETTING STARTED
BATTERY INSTALLATION
Install two (2) “AAA” batteries in the remote control. (Not included)
To ensure safe operation, please observe the following precautions:
•Replace both batteries at the same time. Do not use a new battery with a used battery.
•There’s a risk of explosion if a battery is replaced by an incorrect type.
•Do not expose the Remote Control unit to moisture or heat.
•Be sure to match the “+” and
ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE
Hook up your antenna or your cable service to the HDTV’s ANT terminal with the use of a 75 OHM coaxial cable.
NOTE: Keep your indoor antenna at least 3 ft. away from the televisionset and any other electronic equipment.
ANTENNA
ANALOG / DIGITAL
ANTENNA IN
CABLE
The tuner in this HDTV can receive:
•Digital and Analog off air signals from an antenna
•Analog or ClearQAM cable channels from a direct Cable TV connection.
http://ca.sanyo.com
