Sanyo LNS-T31A, LNS-W31A, LNS-T32 manual Lens Lock Latches

3REMOVE THE LENS (See Figure-3 and 4)

1. Remove the lens motor connector from terminal.

2.Loosen the screws-B (2 screws) which fastens the lens. {Use the driver (4 mm, Yellow) included with the lens to loosen the screws.}

3.Slide the lens lock latches to "UNLOCK" position and remove the lens.

Be careful not to drop the lens when removing the screws. After using, save the driver for latter use.

SCREW "B"

LENS LOCK

LATCHES

CONNECTOR Fig-3

TERMINAL

LENS LOCK LATCHES

4

LOCK

POSITION

UNLOCK

POSITION

Fig-4

MOUNT THE LENS (See Figure-5)

1. Remove protective caps (front and back) on the lens.

2.Mount the lens on lens mounting bracket with

Upper 2 screws. (locate motor on left side).

Use the driver (4 mm, Yellow) included with the lens to fasten the screws.

3. Remove the lower 2 screws on the Lens. (Lower 2 screws are not used.)

Slide the lens lock latches to "LOCK" position and lock the lens. (See Figure-4)

4.Connect the lens motor connector to terminal. (See Figure-3)

LENS MOUNTING

BRACKET

DRIVER

IN THE LENS

LOWER SCREWS

Fig-5

-5-