Sanyo LNS-W32 manual Mount the Front Cabinet and Lens Cover See

5MOUNT THE LIGHT-BLOCK SHEET AND LIGHT-BLOCK SHEET BASE (See Figure-6)

1. Mount the light-block sheet on the lens. (In the same position as the removed sheet has been placed). Use the sheet included with the lens.

Make sure the mark (TOP and BACK) on Light-Block Sheet and set them properly.

2.Mount the light-block sheet base included with the lens.

6MOUNT THE FRONT CABINET AND LENS COVER (See Figure-7)

1. Mount the front cabinet with 2 screws.

Lens cover is not used.

LIGHT-BLOCK

SHEET

Type PC1	LIGHT-BLOCK
(Part No. 610 310 7967)	SHEET BASE

FRONT

CABINET Fig-6

Fig-7

FOCUS ADJUSTMENT

Set up the projector and project image on the screen.

1.Loosen the Focus Lock Screw on the lens.

2.Rotate the lens to obtain proper focus on center area of the screen.

3.Tighten the Focus Lock Screw.

When proper focus is not observed at outer area of the screen, proceed to following adjustments.

4.Loosen the Focus Lock Ring of the lens. (Turn the Lock Ring to counter-clockwise.)

5.Rotate the lens to obtain proper focus on outer area of the screen.

6.Lock the Focus Lock Ring securely. (Turn the Lock Ring to clockwise.)

If proper focus is not observed entire screen, repeat above adjustment 1~ 6.

Focus Lock Ring

Focus Lock Screw

-7-