TROUBLE SHOOTING
If the unit malfunctions, check out the following before calling for service.
Malfunction | Check/Remedy |
The chamber is not cooled | The circuit breaker of power source is active. |
at all | The voltage is too low (In this case, call an electrician). |
| The power is not supplied. |
| The breaker is free. |
| The large amount of articles (load) is stored in the chamber at one |
| time. |
The cooling is poor | The ambient temperature is too high. |
| The latch of inner door is not closed completely. The outer door |
| is not closed firmly. (The frost or ice between the cabinet and door |
| gasket possibly prevents door seal.) |
| The air intake vent is blocked. |
| The condenser filter is clogged. Always clean the filter when the |
| filter check lamp is lit. |
| The door is not shut tightly. |
| The inner door is not installed correctly. |
| The set temperature in the controller is not set properly. |
| The freezer is in the direct sunlight. |
| There is any heating source near the freezer. |
| A rubber cap and insulation are not set correctly. |
| You put too many unfrozen articles into the chamber. |
Alarm test key cannot | The alarm is activated only when the power switch is ON. |
actuate the alarm | When only the buzzer or only the alarm is actuated by the alarm test |
| key, the unactuated part is out of order, and must be replaced. |
Note: |
|
If the malfunction is not eliminated after checking the above items, or the malfunction is not shown in the above table, contact Sanyo sales representative or agent.
If the unit malfunctions, check out the following before calling for service.
- 65 -
23