Sanyo PDG-DWL100 owner manual Powering Off the Projector, Press the “ON/STAND-BY”again to confirm

Powering Off the Projector

1.Press the “ON/STAND-BY” to turn off the projector lamp, you will see a message as below on the on-screen display.

2.Press the “ON/STAND-BY” again to confirm.

3.The cooling fan continues to operate for about 60 seconds for cooling cycle and the POWER LED will flash green. When the light starts flashing orange, the projector has entered standby mode.

If you wish to turn the projector back on, you must wait until the projector has completed the cooling cycle and has entered standby mode. Once in standby mode, simply press “ON/STAND-BY” to restart the projector.

4.Disconnect the power cable from the electrical outlet and the projector.

5.Do not turn on the projector immediately following a power off procedure.

16