Sanyo PDG-DWL100 owner manual Input

Note

To quick change remote control code, press “MENU” and “IMAGE” buttons about 10 seconds at the same time.

Note

The bottom side of OSD menu might be out of display when user adjusts keystone value, under the status of low resolution sig- nal input and different aspect ratio setting. To solve this problem, please adjust keystone value in “Aspect Ratio” of “4:3” then switch back to your desired aspect ratio.

7 INPUT	Press “INPUT” to choose RGB, SCART,
	Component, S-Video, Composite and
	HDMI sources.

8D.ZOOM - Zoom out the projector display.

9KEYSTONE +/- Adjust the image to compensate for

		distortion caused by tilting the projec-
		tor.
10	LAMP CON-	Select the lamp mode. (refer “ECO
	TROL	Mode” function)
11	AV-MUTE	Momentarily turn off/on the audio

and video.

12COMPUTER 1 Press “COMPUTER 1” to choose Com- puter in 1/Component in 1 connector.

13COMPUTER 2 Press “COMPUTER 2” to choose Com-

		puter in 2/Component in 2 connector.
14	FREEZE	Pause the screen image. Press again to
		resume the screen image.
15	Four	Use or or or to select items or
	Directional Se-	make adjustments to your selection.
	lect Keys
16	ASPECT	Display the “Aspect Ratio” section of
		the on-screen display menu to select
		the desired aspect ratio.
17	D.ZOOM +	Zoom in the projector display.
18	INFORMATION Display information menu.
19	VOLUME +/-	Increase/decrease speaker volume.
20	Keypad 1~9	For input a password in the “Security
		settings”.
21	AUTO. ADJ	Automatically synchronize the projec-
		tor to the input source.
22	HDMI	Press “HDMI” to choose HDMI con-
		nector.
23	S-VIDEO	Press “S-VIDEO” to choose S-Video
		connector.
24	VIDEO	Press “VIDEO” to choose Video con-
		nector.

English

9