Setting

Logo

This function decides what to be displayed on the starting-up display as follows:

User . . . . . .the image you captured Default . . . .the factory-set logo Off . . . . . . .count-down only

Capture

This function enables you to capture the image being projected and use it for a starting-up display or interval of presentations. After capturing the projected image, go to the Logo function and set it to “User”. Then the captured image can be displayed when turning on the projector next time or pressing the NO SHOW button. (p22)

To capture the image, select [Yes]. To cancel the Capture function, select [No].

✔Note:

•Before capturing an image, select Standard in the Image Select Menu to capture a proper image. (See page 29, 34.)

•A signal from a computer can be captured up to XGA(1024 x 768). A signal from video equipment can be captured except for 720p, 1035i, and 1080i.

•When capturing the image that has been adjusted by the Keystone function, the adjustment data is automatically reset and the projector captures an image without keystone adjustment.

•When the Logo PIN code lock function is On, the Logo and Capture menu cannot be selected.

Ceiling

When this function is “On,” the picture is top/bottom and left/right reversed. This function is used to project the image from a ceiling mounting the projector.

Rear

When this function is “On,” the picture is left/right reversed. This function is used to project the image to a rear projection screen.

Capture

Select [Yes] to capture the projected image.

Select [Yes] to stop capturing.

Ceiling

Rear

40