Appendix
Before calling your dealer or service center for assistance, check the items below once again.
| Problem: | – Solutions |
|
|
|
|
|
| No power | – Plug the power cord of the projector into the AC outlet. |
|
|
| – See if the POWER indicator lights red. |
|
|
| – Wait until the POWER indicator stops blinking to turn on the projector |
|
|
| again. The projector can be turned on after the POWER indicator |
|
|
| turns red. See page 22. |
|
|
| – Check the WARNING indicator. If the WARNING indicator lights red, |
|
|
| projector cannot be turned on. See page 62. |
|
|
| – Check the projection lamp. See page 65. |
|
|
| – Unlock the Key lock function for the projector. See page 54. |
|
The initial display is not shown. | – Make sure "User" or "Countdown off" are not chosen at display |
| |
| 對 | function.(see page 48) |
|
|
|
| |
The initial display is not same | – Make sure "User" or "Countdown off" are not chosen at Logo (select) |
| |
as the default set. | 對 function.(see page 48) |
|
Input signal switches automatically. – Make sure Input search function is adjusted properly. See page 51.
(or does not switch automatically)
When the projector is on and you | – That is the Filter warning icon. Refer to page 57. |
| |
press the input button, an icon |
|
| |
other than the Lamp mode icon |
|
| |
appears. |
|
| |
|
|
| |
An icon other than Input mode or | – That is the Lamp replacement icon or the Filter warning icon. See |
| |
Lamp mode icon appears. | page 56 or 57. |
| |
|
|
| |
Image is out of focus. | – Adjust focus of the projector. See page 26. |
| |
|
| – Provide proper distance between the projector and the projection |
|
|
| screen. See page 17. |
|
|
| – Check the projection lens to see if it needs cleaning. See page 64. |
|
|
| – Moving the projector from a cool to warm place may result in |
|
|
| moisture condensation on the projection lens. In such cases, leave |
|
|
| the projector off and wait until condensation evaporates. |
|
|
|
|
|
Image is Left/Right reversed. | – Check the Ceiling/Rear function. See page 51. |
| |
Image is Top/Bottom reversed. | – Check the Top/Bottom function. See page 51. |
| |
|
|
| |
Picture is not bright enough. | – Check if the 'Contrast" or "Brightness" are adjusted properly.(see |
| |
|
| page 37,44) |
|
|
| – Check if "Image mode" is selected properly.(see page 36,43) |
|
|
| – Check the lamp control function.(see page 28) |
|
|
| – Check the LAMP REPLACE indicator. If it lights, the end of lamp life |
|
|
| is approaching. Replace the lamp with a new one promptly.(see page |
|
|
| 65) |
|
67