Preparation

Remote Control Transmitter

This wireless remote control uses radio frequency signal. You can switch four frequency channels prepared and select a remote control ID from eight IDs. The Remote Control Channel selection prevents radio frequency interference from the other equipment and the Remote Control ID selection allows you to operate several projectors with their respective remote controls without mutual interference among those projectors.

Wired Remote Control Transmitter

The remote control can be used as a wired remote control. When interference between the projector and other equipment occurs or the projector is used in a place where the operation of radio equipment is restricted, connecting the remote control and the projector with the wired remote cable (POA-CA-RC30) separatery supplied is recommended. (p.73) Connected with the wired remote cable, the remote control does not emit radio signal.

Remote Control Channel and ID Setup

Initial Remote Control Channel and ID are CH1 and ID1. When you

 

 

change the setting, set a Channel first, and then an ID.

MENU INFO

AUTO PC

 

FREEZE

SCREEN

Channel and ID settings for the remote control should be the same as those for the projector. When changing the CH and ID settings to the remote control, do it to the projector as well. Refer to “Remote Control” in Setting menu on page 51.

VOL.

SOUND

P-TIMER

INPUT 1

MUTE

 

 

 

INPUT 4

INPUT 2

CH

 

 

REMOTE

INPUT 5

INPUT 3

CH button

ID

ID button

Should you be lost at which CH and ID are currently set, initialize the Channel and ID once, and set them again.

REMOTE RESET ON ALL OFF

1 Set the Remote Control Channel

Hold down the CH button and press the SELECT button. The Remote Control Channel switches sequentially for one pressing the SELECT button. (See Table 1 on next page.)

2 Set the Remote Control ID

Hold down the ID button and press the SELECT button. The Remote Control ID switches sequentially for one pressing the SELECT button. (See Table 2 on next page.)

Initialize the Remote Control Channel and ID

Press and hold the CH and ID buttons, and slide the REMOTE RESET/ON/ALL-OFF switch to REMOTE RESET, and then to ON. The initial Channel and ID are CH1 and ID1. (p.15)

✔Note:

Remote Control Channel and ID cannot be initialized separately.

SELECT button

While pressing the CH/ID button, press the SELECT button number of times corresponding to the remote control CH/ID.

16