Computer Adjustment

selects Auto PC adj., Fine sync, Total dots, Current mode, Clamp, Display area, Position, V -sync phase, Reset, and Mode.

PC Adjustment

Auto PC Adjust

Auto PC adj.

1

Press the MENU button to display On-Screen Menu. Spin

 

Menu icons with the Point buttons (7 and 8) or the Control

 

pad and press the SELECT button when the PC ADJ. icon

 

comes right in front.

2

Move the yellow frame pointer to Auto PC adj. and then

press the SELECT button twice.

This Auto PC Adjustment can be also executed by pressing the AUTO PC ADJ. button on the top control or the AUTO PC button on the remote control unit. (p.15, 30)

To store adjustment parameters

Adjustment parameters from Auto PC Adjustment can be memorized in this projector. Once parameters are memorized, the setting can be done just by selecting Mode in the System menu (p.38). See Store on page 42.

PC Adjust Menu PC ADJ. icon

Move the yellow frame pointer to the Auto PC adj. and press the SELECT button.

✔Note:

•Fine sync, Total dots and Picture Position of some computers can not be fully adjusted with this Auto PC Adjustment function. When the image is not provided properly with this operation, manual adjustments are required. (p.41, 42)

•Auto PC Adjustment function cannot be operated in Digital Signal input on DVI terminal and 480i, 575i, 480p, 575p, 720p (HDTV), 1035i (HDTV), 1080i/50 (HDTV), or 1080i/60 (HDTV) is selected on the System menu . (p.39)

40