Sanyo PLC-XU74 owner manual Rear Terminal

Part Names and Functions

Rear Terminal

✽ q w e r t y u

Part Names and Functions

qUSB (Series B)

In order to operate the computer with the remote control during a presentation, connect the USB port of the computer to the projector with a USB cable. (p.15)

wSERVICE PORT

This jack is used to service the projector.

eCOMPUTER IN 1/COMPONENT IN

Connect output signal from a computer, R G B s c a r t 2 1 - p i n v i d e o o u t p u t , o r component video output to this terminal. (p.15, 17)

When the cable is of the longer variety, it is advisable to use this terminal and not

COMPUTER IN 2/MONITOR OUT.

rCOMPUTER IN 2 / MONITOR OUT

This terminal is switchable and can be used for input from a computer and video equipment (component or RGB scart 21-pin) or output to the other monitor.

Set the terminal up as either Computer input or Monitor output properly. (Used for Monitor out, this terminal outputs only incoming signal from COMPUTER IN 1/ COMPONENT IN terminal.) (p15, 17, 46)

oi

tS-VIDEO IN

Connect the S-VIDEO output from video equipment to this jack. (p.16)

yAUDIO IN

Connect the audio output from video equipment connected to t or o to this jack. (When the audio output is monaural, connect it to L (MONO) jack.) (p.16)

uAUDIO OUT (VARIABLE)

Connect an external audio amplifier to this jack. (p.15 - 17)

This terminal outputs sound from AUDIO IN terminal (y or i).

iCOMPUTER/ COMPONENT AUDIO IN Connect the audio output (stereo) from a computer or video equipment connected to e or r to this jack. (p 15, 17)

oVIDEO IN

Connect the composite video output from video equipment to VIDEO jack. (p.16)

✽RESET button

A built-in micro processor which controls this unit may occasionally malfunction and need to be reset. This can be done by pressing the RESET button with a pen, which will shut down and restart the unit. Do not use the RESET function excessively.