Sanyo POA-HDTM01 2/6: Image Adjust, 3/6: Information

32

You can adjust contrast and brightness of the output signal from the transmitter.

1. Press the MENU button to show the Menu. Press the Point de buttons to select Main

Menu "2/6: Image Adjust" and then press the SELECT button.

1/2: Contrast Setting

After the step 1;

2. Press the Point de buttons to select Sub Menu "1/2: Contrast Setting" and then press

the SELECT button.

3. Press the Point 7 8 buttons to adjust the contrast (-32 to +32).

2/2: Brightness Setting

After the step 1;

2. Press the Point de buttons to select Sub Menu "2/2: Brightness Setting" and then

press the SELECT button.

3. Press the Point 7 8 buttons to adjust the brightness (-32 to +32).

2/6: Image Adjust

Brightness 2/2

Setting

Contrast 1/2

Setting

Image 2/6

Adjust Brightness

-32

Contrast

+32

TRANSMITTER

Information display can be used to confirm the current output signal from the transmitter.

1. Press the MENU button to show the Menu. Press the Point de buttons to select Main

Menu "3/6 Information" and then press the SELECT button.

2. The information "Link On / RF Frequency", "Link Off RF Frequency", "H/V Frequency"

and "H/V Resolution" will be displayed periodically.

3/6: Information

Link Off

RF Freq. ****MHz

Link On

RF Freq. ****MHz

Information 3/6

or

H Freq. ****

V Freq. ****

H Resol. ****

V Resol. ****

Other Basic Operation

Contents

Main Features and Design Single Mode Broadcast Mode Table of Contents To the Owner CAUTION Safety Precaution Important Notice Safety Instructions Page Air Circulation Caution about Radio Wave Warning Compliance FCC Warning FCC RF Exposure Warning For Canadian Users Federal Communications Commission Notice Compliance Page Preparation Before use Package contents Part Names and Functions Front Rear Cables used for connection Installation Connection to external equipment Connecting the AC Power Cord q w Note on the AC Power Cord e Installing the Receiver into the Projector Receiver Replacement of the Receiver Board Screws Guide Socket Plug Screws Part Names and Functions Basic Setting and Operation Turning on the Projector Input Selection Projector Operation Turning on the Transmitter Turning off the transmitter Input Source Selection INPUT 1 COMPONENT INPUT 2 DVI INPUT 3 HDMI How to Operate the Menu INPUT button Examples of LCD Display Menu Tree Single Mode Operation Broadcast Mode Operation Flow of Installation Mode TRANSMITTER PROJECTOR When using a pair of transmitter and receiver for the first time Main Menu 6/6: Mode Select Main Menu 1/6: Single Mode Setup a Sub Menu 1/2: Authentication Single Mode Operation 6/6: Mode Select & 1/6: Single Mode Setup Mode select Authentication Page Page Main Menu 6/6: Mode Select Main Menu 4/6: ID Number Broadcast Mode Operation 6/6: Mode Select & 4/6: ID Number Mode select Input ID 1/1: Output Level Select Reception Level To enter a new Lock Key To set Key Lock 5/6: Key Lock Other Basic Operation To change Lock Key To release Lock Key Menu Tree of Key Lock 1/2: Contrast Setting 2/2: Brightness Setting 2/6: Image Adjust 3/6: Information Reset Function of the projector Reset Maintenance and Care Appendix Troubleshooting Specifications Page Compatible Signals Specifications Appendix SERIAL CONTROL PORT (Mini D-sub 9 pin) INPUT 2 : DIGITAL DVI-D (DVI 24 Pin) INPUT 3 : HDMI (19 Pin Type A) Configurations of Terminals