Sanyo POA-HDTM01 Rear

English

13

HD DATA WIRELESS TRANSMITTER BOX

OWNER'S MANUAL

qINPUT 1 COMPONENT

Connect component output signal

(Y-Pb/Cb-Pr/Cr) from video equip-

ment to this terminal.

wINPUT 2 DIGITAL (DVI-D)

Connect DVI digital output signal

from computer to this terminal.

eINPUT 3 HDMI

Connect HDMI output signal from

video equipment to this terminal.

This input is only available in the

single mode.

✐ -

This input cannot be selected in the

broadcast mode.

- When selecting this input in the single

mode, the "Broadcast Mode" cannot

be selected in "Mode Select".

rDC 16V

Connect the AC adapter (supplied).

tSERIAL

- This terminal is used to service the

transmitter.

- If you control the transmitter by

computer, you must connect a se-

rial cross cable (not supplied) from

your computer to this terminal.

yVENTILATION SLOT

Do not cover the ventilation slot

during operation.

Rear q w e

r t y

Preparation

Note:

When you want to use the transmitter in the upright position, you

can use the supplied 2 stands. The antenna is provided near the

ventilation slot, so it is recommended to stand the transmitter as

shown in the figure for keeping the wireless communication in

good condition.

Contents

Main Features and Design Single Mode Broadcast Mode Table of Contents To the Owner CAUTION Safety Precaution Important Notice Safety Instructions Page Air Circulation Caution about Radio Wave Warning Compliance FCC Warning FCC RF Exposure Warning For Canadian Users Federal Communications Commission Notice Compliance Page Preparation Before use Package contents Part Names and Functions Front Rear Cables used for connection Installation Connection to external equipment Connecting the AC Power Cord q w Note on the AC Power Cord e Installing the Receiver into the Projector Receiver Replacement of the Receiver Board Screws Guide Socket Plug Screws Part Names and Functions Basic Setting and Operation Turning on the Projector Input Selection Projector Operation Turning on the Transmitter Turning off the transmitter Input Source Selection INPUT 1 COMPONENT INPUT 2 DVI INPUT 3 HDMI How to Operate the Menu INPUT button Examples of LCD Display Menu Tree Single Mode Operation Broadcast Mode Operation Flow of Installation Mode TRANSMITTER PROJECTOR When using a pair of transmitter and receiver for the first time Main Menu 6/6: Mode Select Main Menu 1/6: Single Mode Setup a Sub Menu 1/2: Authentication Single Mode Operation 6/6: Mode Select & 1/6: Single Mode Setup Mode select Authentication Page Page Main Menu 6/6: Mode Select Main Menu 4/6: ID Number Broadcast Mode Operation 6/6: Mode Select & 4/6: ID Number Mode select Input ID 1/1: Output Level Select Reception Level To enter a new Lock Key To set Key Lock 5/6: Key Lock Other Basic Operation To change Lock Key To release Lock Key Menu Tree of Key Lock 1/2: Contrast Setting 2/2: Brightness Setting 2/6: Image Adjust 3/6: Information Reset Function of the projector Reset Maintenance and Care Appendix Troubleshooting Specifications Page Compatible Signals Specifications Appendix SERIAL CONTROL PORT (Mini D-sub 9 pin) INPUT 2 : DIGITAL DVI-D (DVI 24 Pin) INPUT 3 : HDMI (19 Pin Type A) Configurations of Terminals