Sanyo STW-2 Series Care and Cleaning, Fan Cycle Switch, Air Filters, Freeze Protection

Models: STW-2 Series

1 12
Download 12 pages 15.31 Kb
Page 4
Image 4
Fan Cycle Switch

Fan Cycle Switch

The Fan Cycle Switch is located under the control panel behind the front grille. This switch is set to CONT at the factory to provide continuous fan operation in cool or heat modes. Leaving the switch at the CONT setting allows continuous circulation of room air and will keep the room temperature at stable condition. If you want the fan to cycle on and off with the compressor or electrical heater, set the switch to CYCLE.

 

THERMOSTAT

SELECTOR

 

LOW

OFF FAN

LOW

 

HEAT

 

 

HIGH

 

COOL

 

 

HIGH

 

HEAT

 

 

 

 

COOL

WARMER

COOLER

 

 

 

 

 

Care and Cleaning

Turn off the air conditioner before cleaning.

Air Filters

The air filters should be cleaned at least once every two weeks. Clogged filters reduce cooling, heating and air flow.

Keeping these filters clean will:

Decrease cost of operation.

Save energy.

Prevent clogged heat exchanger coils.

Reduce costly compressor problems.

To remove the air filters:

Pull up

2 air filters

Knob

Control panel

 

THERMOSTAT

SELECTOR

 

LOW

OFF

FAN

 

 

LOW

 

HEAT

 

COOL

 

HIGH

 

HIGH

 

HEAT

 

 

 

COOL

WARMER

COOLER

 

 

CYCLE

CONT

 

Fan cycle switch

Freeze Protection

Freeze Protection helps prevent plumbing damage due to sub-freezing temperatures — even if you have turned the mode selector switch to OFF. The unit automatically turns on the heater and fan if the room temperature falls to about 46°F.

You do not have to do anything to activate the Freeze Protection. It will work as long as power to the unit has not been interrupted.

Front

To clean the air filters:

Vacuum off heavy dirt.

Run water through the filters.

Dry thoroughly before replacing.

To reinstall the air filters:

Push down

NOTE

Do not operate the air conditioner without the filters in place. If a filter becomes torn or damaged it should be replaced immediately. Operating the unit without the fil- ters in place or with damaged filters will allow dirt and dust to reach the indoor coil and reduce the efficiency of the unit.

Replacement filters (STK01AF) are available from the deal- er or installer.

Front Grille & Wall Case

Wash the front grille and wall case finish with mild soap or detergent and lukewarm water.

4

Page 4
Image 4
Sanyo STW-2 Series Care and Cleaning, Fan Cycle Switch, Air Filters, Freeze Protection, Front Grille & Wall Case