PREPARATIONS AND CONNECTIONS

Concerning the coaxial cable

To connect the camera to peripheral devices, use a coaxial cable with BNC plug.

•Cable type RG-6U (5C-2V), 500 m maximum.

•Cable type RG-11U (7C-2V), 600 m maximum.

If the type of peripheral devices connected, the type of cable used and/or the cable length are not as specified, the image and synchronization signals may not be transmitted correctly.

CAUTION:

Use CCTV/Video grade coaxial cable. Due to its construction, an RG-59U cable will not transmit the signal properly when installed through conduits or through the air, and therefore cannot be used.

Installing the BNC plug (sold separately)

1Cut the extremity of the coaxial cable (sold separately), as illustrated.2Insert the cable through the adaptor, then turn the shielding mesh over.

3Loosen the center wire securing screw of the plug, then install the cable in the BNC plug, so that the center wire is threaded through the plug center opening.

Before tightening the center wire securing screw, make sure the center wire comes out through the plug center opening.

4Screw the adaptor onto the plug.

12

7mm 8mm

34

English 7