CONNECTIONS AND INSTALLATION

Coaxial cable connection

1Cut and prepare the extremity of the coaxial cable (sold separately), as illustrated.

2Attach the coaxial cable to the base.

Loosen the CAMERA (VIDEO) OUT terminal screw (A) and the GND terminal screw (B), then insert the center wire of the coaxial cable in the CAMERA (VIDEO) OUT terminal and make sure the shielding mesh part of the cable is located under the GND terminal plate, then tighten both screws (A and B) to attach the cable.

CAUTION:

If the base is installed on a wall or if for any other reason the cable cannot be run behind the installation surface, break-off the tab (C) with nippers to allow the cable to go through.

Camera installation

1Install the base on the ceiling, etc., using the four supplied tapping screws (A).

•This camera is not waterproof. It cannot be installed outside.

•When installing the base, make sure to verify that the installation surface will allow full tightening of the screws. Plaster board, etc., may not give a strong enough installation, and it is recommended to use a reinforcement, or other method so that the screws are anchored securely.

CAUTION:

When installing the base on a wall, make sure to align it as indicated in Fig. 1.

27mm

14

3 10mm

 

 

 

 

1

(Cut the shielding mesh here)

A B

2C

 

A

 

( )

Fig 1.

( )

 

 

English 9