Sanyo VCC-9624 Zoom and focus adjustments, NOTE:, Loosen the focus ring knob, then turn the ring towards, 4Repeat steps 2 and 3 until the desired image is obtained

SETTINGS AND ADJUSTMENTS

Zoom and focus adjustments

After the camera has been installed, the zoom and focus must be adjusted while viewing on a monitor the transmitted image.

1Remove the lens cover, then press on both sides of the secondary lens cover to remove it.

2Loosen the zoom ring knob, then turn the ring towards T or W as necessary.

•T (zoom in) side

The range will be smaller and the subject larger.

•W (Zoom out) side

The range will be wider and the subject smaller.

3Loosen the focus ring knob, then turn the ring towards ∞ (infinity) or N (near) as necessary.

4Repeat steps 2 and 3 until the desired image is obtained.

When finished, tighten the zoom ring and the focus ring knobs. Then, install the secondary lens cover, making sure it snaps in place and install the lens cover.

NOTE:

While making these settings, be very careful not to scratch or damage the lens.

1

2

3

14 English