Pioneer PDA-5003, PDA-5004 manual How to route cables, To attach the speed clamps to the display

How to route cables

Speed clamps and bead bands are included with the plasma display for bunching cables together. Once components are connected, follow the following steps to route cables.

The illustration depicts the PDP-504CMX/PDP-50MXE1/ PDP-50MXE1-S with video card PDA-5003.

1 2

Installation and Connections

English

* As viewed from the rear of the display.

1 Organize cables together using the provided		2 Bunch separated cables together and secure them
	speed clamps.		with the provided bead bands.
	Insert 1 into an appropriate hole on the rear of the		Do not allow excessive stress to be placed on the
	unit, then snap 2 into the back of 1 to fix the clamp.		ends of cables.
	Speed clamps are designed to be difficult to undo	Note
		Cables can be routed to the right or left.
	once in place. Please attach carefully.
To attach the speed clamps to the display		The illustration depicts the PDP-504CMX/PDP-50MXE1/
Connect the speed clamps using the 6 holes marked
	‡	PDP-50MXE1-S with video card PDA-5003.
with “ ” below, depending on the situation.
				* As viewed from the rear
				of the display.

To remove speed clamps

Using pliers, twist the clamp 90° and pull it outward.

In some cases the clamp may have deteriorated over time and may be damaged when removed.

17

Installation and Connections

En